How to install dsh-im
Install command, configuration and the one gotcha — taken from xmanrui/dsh-im's own README, not invented here.
Repo: xmanrui/dsh-im · Stars: 2375 · Category: UI & Themes
Install
Copy from your project's README (source: upstream). The README gives 2 install paths — pick the one matching your setup.
dsh plugin --profile desktop add -w @xmanrui/dsh-imdsh plugin --profile web add -w @xmanrui/dsh-imAfter installing, restart the DSH session. A plugin that is installed but does not load is almost always a profile mismatch — see nine causes of "plugin installed but not loading".
Configuration
- id: xmanrui-dsh-im
config:
rpcAuthority: loopback- id: xmanrui-dsh-im
config:
language: enWhat it does
通过扫码、App Manifest 或已有机器人凭据把 IM 机器人接入 DeepSeek Harness，并让本机 Harness 主动连接公网 AI Office。一个插件、一个设置入口，统一管理内置 IM 渠道和 AI Office Connector。每个 IM 渠道都支持接入多个机器人，各机器人的连接状态、工作区、模型和会话绑定彼此独立；iMessage 是本机 Messages.app 身份接入的例外，详见iMessage 渠道说明。
Connect IM bots to DeepSeek Harness by scanning a QR code, using an App Manifest, or entering existing bot credentials, and let the local Harness connect outward to a public AI Office. One plugin and one settings entry manage the built-in IM channels and the AI Office Connector.
Caveats before you install
- The upstream README is written in Chinese. The commands below are verbatim; the surrounding explanation on this page is ours.
- The command above was copied on 2026-10-25. If it fails, the README is the authority, not this page.
- This site does not execute plugin code. Install commands are reproduced, not tested.